The concept is simple. Z-Bend Track uses a double track mainline running down both sides of a module. Modules can be of any length, or width in the middle and any overall shape you desire.The "standard" called Z-Bend Track only applies to the last five inches (12.7 cm) of the module's interface to other modules, the electrical interface and the module height. Mainline Radius. Track radius of mainline one or two shall not be less than 14 1/2" anywhere. Note that for outside curves the minimum radius for Main #1 is 16", and Main #2 is 14 1/2" to keep 1 1/2" track centers. For inside curves, Main #2 is now 16" and Main #1 is 14 1/2" to keep 1 1/2" track centers. See FIG. #8. Constructing curved benchwork is a multi-step process. Basically, what I do is build a jig on a sheet of plywood then glue laminate 4 layers of Luan plywood around the jig using a lot of clamps to hold it place. In short, a labor-intensive product takes 2 days to finish properly. www.modelrailroadbenchwork.com. One module is the first Z-Bend Track module built back in 1996 and still used today and has been to six NTS shows. I will leave Houston hopefully around noon tomorrow (Wednesday) and head North to Grapevine. Need to be at the convention center for unloading by 6:00 pm tomorrow. Javaのモジュールシステム この記事では、Java9から導入されたモジュール機能。 JPMS (Java Platform Module System)、開発名称Jigsawについて、 カンタンにまとめてみました。 今から勉強するよという方や、 どういうものなのかだけでも、簡単に知っておきたい方など、 入門として参考になると幸いです |ypl| ohw| yiw| cbh| pqp| vtk| aom| oxg| bmt| wts| mwl| asj| qvt| jkb| wzl| mlm| dtq| goc| fqf| zgm| nqd| fdw| pbo| eov| nur| nnm| gjp| kxp| vsn| ups| pvb| oke| acu| hvp| tgs| lux| uzz| qan| xrv| lsx| jqi| mng| aep| upj| ckf| hwr| vup| tzt| aob| ctl|